Approx/Approx_SameParameter.cxx,hxx:
Class Approx_SameParameter refactoring. Logic is changed in many places to unify usage, simplify maintenance.
Method Curve2d() is changed to return Geom2d_Curve instead of Geom2d_BSplineCurve. Corresponding message is added to the upgrade guide.
.lxx file is merged into .hxx.
Tangent computation is extracted into special method.
Comparing number of sample points after CheckSameParameter(...) is added to define cases with projection fails.
Undesirable behavior when curves are not same parameterized is fixed.
Geom2dAdaptor/Geom2dAdaptor.cxx: treatment of offset curve is added
Adaptor3d/Adaptor3d_TopolTool.cxx: minor improvement of performance for BSpline surfaces with huge number of knots
Tests were modified according to new behavior of sameparameter algorithm
Interpolation state check is fixed to mark as valid only ordered sequences of poles.
Refactoring of Approx_SameParameter.cxx.
Test case is added.
Test cases are updated to the new behavior.
Update of testing cases
1. B-spline cache was moved into separated classes: BSplCLib_Cache for 2D and 3D curves and BSplSLib_Cache for surfaces.
2. The cache is used now in corresponding adaptor classes (Geom2dAdaptor_Curve, GeomAdaptor_Curve and GeomAdaptor_Surface) when the curve or surface is a B-spline.
3. Algorithms were changed to use adaptors for B-spline calculations instead of curves or surfaces.
4. Precised calculation of derivatives of surface of revolution is implemented for the points of surface placed on the axis of revolution (Geom_SurfaceOfRevolution.cxx)
5. Small modifications are made to adjust algorithms to new behavior of B-spline calculation.
6. Test cases were modified according to the modern behavior.
7. Changes in BOPAlgo_WireSplitter, BOPTools_AlgoTools, BRepLib_CheckCurveOnSurface and ShapeAnalysis_Wire to use adaptors instead of geometric entities
8. Allow Geom2dAdaptor and GeomAdaptor in case of offset curve to use corresponding adaptor for basis curve
Modification of test-cases according to the new behavior.
Test for sewing command were updated to check reference information.
Commands for testing were moved to the file src/DrawResources/CheckCommands.tcl
Documentation overview was updated.
