Upgrade check of closeness of 2dcurve to line during projection:
For C1 and more surfaces check distance to normal, not to surface, for C0 surfaces update tolerance formula.
Add check for possible period jump in some inner point.
Update some test cases.
Add cache saving for lines,
update fixPeriodicTroubles() function, using parameters from cashe.
Small correction of test cases for issue #26930
fix processing of points from cache.
Update of test cases according to the new behavior
Fix behavior of fixPeriodicityTroubles() on different isolines,
fix copy/paste mistake.
Update test cases:
iges_2 C4 - return to master values
step_3 E6 - improvement.
A tool to remove tails from the wires of a shape was created.
The tool is based on mechanism 'ShapeFix',
is located in types 'ShapeFix_Wire' and 'ShapeAnalysis_Wire',
is enabled through method 'ShapeFix_Wire::FixTailMode' and
is initialized by methods 'ShapeFix_Wire::SetMaxTailAngle' and 'ShapeFix_Wire::SetMaxTailWidth' and
is called through method 'ShapeFix_Wire::FixTails'.
The status of any performing of the last method is accessible through method 'ShapeFix_Wire::StatusFixTails'.
The tail angle is checked only at the tail start.
Mechanism 'ShapeFix' was modified:
- the tool is disabled by default;
- algorithm 'Fix notched edges' is disabled then the tool is enabled;
- the tool and the last algorithm work in turns then the tool works on the request.
'Draw' command 'fixshape' was extended by options '-maxtaila' and '-maxtailw' to test the tool.
'Draw' tests to test the tool were created.
Algorithm 'fixshape' was changed in type 'ShapeProcess_OperLibrary' to
- use new parameters named 'FixTailMode', 'MaxTailAngle' (in degrees) and 'MaxTailWidth' from the algorithm context;
- apply the tool after the shape will be fully fixed if the tool was enabled.
Place holders for the new parameters were created in the resource file of mechsnism 'STEPControl_Reader'.
Test cases for issue CR26261
